MAINTENANCE AND USE OF INDUSTRIAL SYNCHRONOUS BELTS？

First, the maintenance of the industrial synchronous belt

1, The industrial synchronous belt in transportation and storage should be kept clean to avoid direct sunlight or rain and snow soaking to prevent contact with acids, alkalis, oils, organic solvents, and other substances, and away from the heat device outside one meter.

2, storage warehouse temperature should be kept between 18-40 ℃, and relative humidity should be kept between 50-80%.

3, storage period, industrial synchronous belt shall be placed in rolls, not folded, and placed during the quarter should be turned once.

4, different types and specifications layers of industrial belts should not be connected to use, the joints are used for to glue method.

5, industrial synchronous belt type, structure, specifications, and number of layers should be based on the use of reasonable conditions.

6, industrial synchronous belt running speed generally should not be greater than 2.5 m / s, block size, abrasive materials and the use of fixed unloading device should try to use low speed.

7, the conveyor's drive roller diameter and industrial belt fabric layer relationship, drive roller, reversing roller matching and the requirements of the roller groove angle should be based on the design of the conveyor, a reasonable selection.

8, the feeding direction should follow the running direction of the industrial belt, to reduce the impact of the material falling on the industrial belt should be adopted chute, reduce the material falling distance; the industrial belt receiving section should shorten the roller spacing and the use of buffer rollers for the leakage of material, the belt should be used with a soft moderate baffle, so as not to baffle plate is too hard to scrape the surface of the industrial belt.

Second, the use of industrial synchronous belt instructions:

1, avoid the rollers are covered with materials, resulting in rotary failure, to prevent leakage of material stuck between the roller and industrial belt, pay attention to the lubrication of the active part, but shall not be oil stain industrial belt;

2、Avoid starting with load;

3, the industrial belt run off, should take timely measures to correct;

4, found that the tape's local damage should be repaired in time to avoid expansion;